XFINITY Home Battery Replacement: XHK1 Keypads

XFINITY Home Battery Replacement: XHK1 Keypads


This video will show you how to replace batteries
in the following XFINITY Home keypads. You’ll need four non-rechargeable AA batteries. First, be sure to disarm your XFINITY Home
security system. Now, firmly grasp the front of the keypad
and gently slide it up to remove the back cover. After removing the cover from the sensor – you
may receive a “tamper alert” from your system. The tamper alert warns you when the cover
of your device is open and will clear once the battery is replaced and the cover is reattached. Avoid touching the tamper switch while the
cover is off. Touching the tamper switch may reset the sensor
to factory settings. Flip the keypad over to access the battery
compartment. Next, remove the old batteries and put them
aside for proper disposal. Use the plus and minus symbols on the diagram
inside the battery compartment to line up and insert the new batteries. Once the battery is inserted correctly, a
small green light next to the battery compartment will light up Attach the cover by aligning the posts on
the back cover with the slots on the keypad and sliding it down until it snaps into place. Visit xfinity dot com slash XFINITY Home Battery
Replacement for additional information on replacing batteries in your XFINITY Home Devices. XFINITY. The future of awesome.

Leave a Reply

Your email address will not be published. Required fields are marked *