Maximus Answer™ Chime Bypass | Installation Video

Maximus Answer™ Chime Bypass | Installation Video


Welcome to the installation video for
the Maximus Answer™ chime bypass You’ll need to install this to make sure your
home’s chime works properly with the Maximus Answer™ You’ll need the chime bypass and the adhesive sticker included in the box You’ll also need a screw driver First, locate your home’s chime box by
ringing your doorbell Turn off power to your existing doorbell and chime box at your home’s circuit breaker Remove the cover from your home’s chime box by lifting it or unscrewing it Take a picture of the wiring. You may need this for reference later Loosen the connector screws on the terminals that connect to your doorbell and transformer FRONT / TRANS connects to the front door and
TRANS / REAR connects to the back door Now get your chime bypass Connect the spades to the two terminals.
The color and orientation of the bypass wires does not matter Do not remove the screws or the existing wires Then, tighten the screws to the terminals
again When you’re finished, you can use the
bypass sticker to secure your chime bypass Peel off the backing to the sticker and adhere it to your chime bypass Peel off the backing on the other side.
Find a place to secure your chime bypass It may be secured inside or outside of
the chime box depending on your setup Put the cover back on your home chime
box. This completes the chime bypass installation Please continue to your
Maximus Answer™ doorbell installation

Leave a Reply

Your email address will not be published. Required fields are marked *