Invisible InfraRed (IR) Intruder Alarm – B1P10 – (BBox 1)

Invisible InfraRed (IR) Intruder Alarm – B1P10 – (BBox 1)


We are now going to build an invisible
alarm system using an infrared LED and photo transistor. The LEDs we have been
using so far emit light that is visible to the human eye.
However, infrared LEDs emit light at a wavelength which is not visible to the
eye. The beam can be seen by using cameras that don’t have an IR filter. For
example, the front-facing cameras of most phones. IR LEDs are commonly used in all
sorts of TV remote control units. The theory is this: if you have an invisible
IR beam then you can place a detector directly in its path, which will monitor
this beam. If the beam is broken for whatever reason, you can identify this
and sound the alarm. The detector that we will be using is called a photo
transistor and it does not have a base terminal but is switched ON when light
shines on it. It also has a coating applied to it which makes it less
sensitive to visible light. This is what the resulting circuit looks
like. We have an IR LED and just like a regular LED it has an anode and cathode.
We have an LED controlled by a PNP transistor which means that the base has
to be at a lower potential compared to its emitter for it to switch ON. Under
normal circumstances light from the IR LED will shine onto the photo transistor
and this will cause a current to flow through it. This current will form a
voltage drop across R3 which is given by Ohm’s law and the positive voltage
will switch OFF Q2. When the beam is interrupted, no current will flow through
the photo transistor and R3 will pull the base of Q2 to the ground potential,
switching it ON. This will turn ON the LED. Let’s build and test the circuit.
Make sure the IR LED and photo transistor are facing each other. We are
only using an LED here to keep things simple and we will learn about relays,
buzzers later which can be used to control more devices or to create an
audible alarm. You can also add multiple sets of emitter-detector pairs to create
a complex alarm system. Let’s move on to the next project.

Leave a Reply

Your email address will not be published. Required fields are marked *