Honeywell Door Sensor Change Battery

Honeywell Door Sensor Change Battery

to change the batteries in your
Honeywell door sensor open up the sensor by pushing in right here on this tab the
top will open up there’s your battery this is a cr123a battery sometimes
called a photo lithium battery just simply pop it out and make special note
on the inside you have negative and positive labeled on your battery it
should hit the same thing just like a double a triple a battery put the
negative side in first push it down and replace the top cover start with the
backside where the hooks swing it board and squit stamp it shut

1 Reply to “Honeywell Door Sensor Change Battery”

  1. After this new keypad was installed>>> I disconnected the power supply and the battery in the control panel. When power was reapplied the panel rebooted, recognized the new keypad and everything worked as expected.

Leave a Reply

Your email address will not be published. Required fields are marked *