Elevator Security Camera with Wireless CCTV Transmission System

Elevator Security Camera with Wireless CCTV Transmission System


This video demonstrates the normal and low
light infrared capability of the ELT-29 elevator security camera, which can be used with or
without the wireless elevator transmission system seen here. To test this CCTV camera,
I mounted it in the corner of my office which is nine and a half feet wide by eleven and
a half feet deep. This is larger than most elevators but as you can see, the camera does
not have any blind spots, even if the area was much smaller. The 2.9 millimeter lens
captures an angle of view that is wider than 90 degrees without any distortion or warping.
I found through my installation and testing that although this camera was originally designed
for elevator surveillance, it actually looks great as a corner mount camera in an office
and being that it has built in infrared LED’s that can see in zero light, it can be effective
for elevator and non elevator systems. Here is the video footage that I captured. I enter
the office through the doorway that’s located directly below the camera, and notice how
the wide angle lens actually captures the door that is located directly below it. There
is literally no blind spots in this small room. I open up the blinds.
I’m just going to make sure I have full light in this room so that you can see the color
picture that this camera gets under normal lighting conditions. Then I’m going to go
ahead and shut the blinds and turn off the lights so that the camera switches to infrared
mode. When it does this, it will appear like there’s a lot of light coming in through that
window but there’s really not. It’s just because the camera is so sensitive that it looks bright
in this room but it’s extremely dim, there’s almost no light and you can see the camera
does a great job in infrared mode. I’ll flip the lights back on and the camera will turn
back to color daytime mode. And there’s our video test.
As mentioned, the ELT-29 can be used with an optional wireless video transmission system,
made specifically for elevator installations. Here’s how it works. The camera is hardwired
to the wireless transmitter using RG59 coax cable. This is just like any standard CCTV
camera installation. The transmitter encodes the video into an optical laser signal. This
guarantees that there is no interference from other wireless technologies such as wifi or
radio frequency. This is extremely reliable. The laser signal is sent through a receiver
unit where it is decoded back into an analog video signal. The receiver unit can then be
connected to any CCTV DVR or monitor using RG59 coax cable. For more information on the
ELT-29 elevator camera and the optional wireless video transmission system that CCTV Camera
Pro supplies, please visit www.cctvcamerapros.com/elevator. Thank you for watching.

2 Replies to “Elevator Security Camera with Wireless CCTV Transmission System”

  1. Elevator Security Camera with Wireless CCTV Video Transmitter
    This video shows the normal and infrared surveillance video that the ELT-29 elevator camera can capture.

    The optional wireless CCTV transmission system uses an optical laser to transmit the video up to 1350 feet (about 90 floors). Because the system uses optics, there is no risk of WIFI or RF signal interference. This system is extremely reliable once it is setup.

    Although the ELT-29 was originally designed for elevator surveillance, the camera looks great in offices and other types of room inside building.

    For more information on the camera and wireless system, please visit this page.
    http://www.cctvcamerapros.com/Elevator

Leave a Reply

Your email address will not be published. Required fields are marked *