Chuango Open Box Video — 105S On-Site Alarm System

Chuango Open Box Video — 105S On-Site Alarm System


Hello there, welcome to our Chuango video
channel. in this video we will show you the 105S Plug&Play alarm system. It’s very easy to
use and can be set up within a minute. How does this alarm
system work. The basics of this system is very easy. When a sensor has been triggered it will send a signal to the control
panel. The control panel will sound the built-in siren immediately all products in this kit can also be
used as accessories for the whole Chuango alarm panel range. The kit contains the WS-105 control panel and siren, a door/window contact including
its double sided tape, two remote controls the PIR motion detector including its
bracket a screw set, warning decals and the user manual. Let’s have a look at the door/window contact. First we pull the strap out of the sensor. Keep the triangles of the door/window contact pointed to each other. Next we press the button on the siren for about half a second until a beep is
heard. Now we separate the magnets from the sensor and the LED indicator on the sensor will
be seen which means it has been triggered. The
siren beeps twice telling us it has already been paired successfully Installation can be done at the site of
a door or window opening. Place the sensor on the side and the
magnet on the door or window itself. Make sure the triangles face each other
and keep the distance within one centimeter. Then let’s have a look at the PIR motion detector. again we pull the strap out of the
motion detector. It will start testing for about 30 seconds. When the detector sees movement twice
within three minutes the detector goes into sleeping mode in order to save power. This means it
will not be triggered and will not send a signal to the
control panel. To connect a device press the button on the siren for about half a second until a beep is heard. then click twice on the button at the
backside of the motion detector in order to send a signal. Installation height is best at 2.2 meters. This will give a range of about 8 meters
at 110 degrees wide. Every product in this kit, including this
siren can be used as an accessorie for any Chuango panel. The PIR motion detector and the magnet
contact can be installed with the normal pairing mode. To install the WS-105 on a different Chuango control panel the siren needs
to be in pairing mode this means pressing the button for about
half a second until it beeps heard. Then press the arm
button on the Chuango control panel. The siren will beep once, indicating it is
connected. Thank you for watching. I hope you
enjoyed it. Feel free to follow our channel for
upcoming videos and products. For more information go to www.chuango.com

Leave a Reply

Your email address will not be published. Required fields are marked *