CCTV Video Multiplexer for AHD, HD-TVI, HDCVI, Analog Security Cameras

CCTV Video Multiplexer for AHD, HD-TVI, HDCVI, Analog Security Cameras


The VM-HD16 is a 16 channel CCTV video multiplexer
that supports analog and HD over coax type security cameras. All 16 BNC inputs can accept video from analog,
AHD, HD-TVI, and HDCVI security cameras. This configuration screen lets users select
the camera type of each channel and also whether the cameras are NTSC or PAL format. During this video demo, I am controlling the
multiplexer with this wireless remote control that is included. Using the remote, I select the 4 camera quad
view. I can cycle between cameras 1 through 4, 5
through 8, and so on by clicking on the quad view button multiple times. Next, I select the 9 camera view. I can switch the view between cameras 1 through
9 and 8 through 16 by clicking on the 9 camera view button multiple times. Next I can use the numbered buttons on the
remote control to select the single camera / full screen view for any camera. Here I press 1, then 2, then 3, so on and
so forth. Next, I select the picture in picture mode
which displays one camera full screen and another much smaller in the lower right. I can change which cameras are display in
PIP mode from this screen. This configuration screen also lets me select
which security cameras are displayed in 2 camera mode. You can see that when I exit the menu system,
the settings are saved and the full screen camera view is changed to camera number 3. Next, I press the mode button to switch the
this alternate 4 camera view. I press mode again to switch to the dual camera
vertical screen. I press mode again to switch to dual camera
horizontal view. Again to switch to the 3 camera view. Then, 6 camera view. And one more time to switch back to picture
in picture mode. Next, I am going to enable the auto-sequence
mode. Auto-sequence displays a full screen single
camera view and rotates the video display automatically from one camera to the next. The hold time can be adjusted for each camera
on this settings screen. Each camera can be held for a different number
of seconds. On the image settings screen, users can adjust
the brightness, contrast, saturation, and hue of each camera. This is also where each camera can be given
a display title. Here is the front and rear view of the VM-HD16’s
1U rack mount case. The rack mount hardware is included. In addition to the wireless remote control,
this multiplexer can be controlled using the buttons on the front of the case. On the back of the device, you can see the
16 BNC video inputs and 16 BNC loop outputs. The loop outputs allow you to optionally send
each video signal to a second device such as a DVR or monitor. Full 1080p resolution is supported by both
the HDMI and VGA video outputs. There is an analog BNC video output also. To learn more, please visit www.cctvcamerapros.com/HD16. Thank you for watching.

1 Reply to “CCTV Video Multiplexer for AHD, HD-TVI, HDCVI, Analog Security Cameras”

  1. I have 2 question for you, how any one can connect this multiplexer to external multiple TV's and Please suggest Multiplexer for IP Camera's.

Leave a Reply

Your email address will not be published. Required fields are marked *