2GIG-DW40-345: Go!Control Installation Front Door

2GIG-DW40-345: Go!Control Installation Front Door


when installing any 2gig door window sensor
first locate the raised guides on one side of the sensor which will need to
match up to the raised arrow on the magnet when installed the gap between
the raised markings on the sensor and the raised arrow on the magnet should be
less than half an inch the sensor can be mounted either on the door or on the
door jamb provided there is room for the sensor to sit flush to the surface in
the case of a door with molding you will most likely need to install the magnet
on the molding and the sensor on the door simply peel the adhesive tape off
the back of both the sensor and the magnet and adhere them to the surface
once again be sure to align the raised marks on the side of the sensor with the
raised arrow on the magnet the sensor can also be secured to the door or frame
using the provided screws for a more secure installation make sure to
subscribe to our youtube page and click the show more tab underneath the video
where you can view valuable links pertaining to this product similar
how-to videos and our low-cost no contract alarm monitoring services

Leave a Reply

Your email address will not be published. Required fields are marked *